Barriers of all types are used throughout the world to prevent intrusion into restricted areas or retain personnel or goods within restricted areas. At times personnel or goods must enter or leave the restricted areas, resulting in the requirement for at least part of the barrier to be moveable.
Stronguard™ Interceptor is much more that an access control system- the UK's first surface mounted gate (SMG).
Stronguard™ Interceptor can be installed with foundations required for the fixing bolts of 500mm, meaning installation can be performed with the minimum of disruption to the surrounding areas and underground services.
Hand built and manufactured under one roof, the Stronguard™ Interceptor is constructed from the highest quality materials. Workmanship is quality assured to ISO 9001, with the welding performed to EN287(BS4872), and fully tested by TRL (Transport Research laboratory) to PAS 68:2007 with a 7.5 tonne truck travelling at 50mph (80km/h).PAS CLASSIFICATION V/7500 (N3) / 80 / 90: 0/0 [size of gate tested 4.5m clear opening]
Product Overview
- Counter balance gate system.
- Standard gate height 1300mm.
- Gates can be extended in height for added security
and to satisfy individual requirements.
- Standard gate widths available - 3.5m, 4.0m, 4.5m,
5.0m, 5.5m.
- Non-standard widths are available on request.
- Gate leaf, 2 buttresses and rear ground beam for
surface mounting.
- 8 polypropylene side rollers fully ball raced located
inside main buttresses.
- 2 stainless steel main support roller and shaft all fully
ball raced.
- 2 stainless steel rear roller assemblies fully ball
raced complete with track cleaning brushes.
- Gate frame and posts fabricated from rolled steel
hollow section and universal beam, rear ground
beam fabricated from twin parallel fangled channels.
- Gate, rear ground track and posts all painted to
individual requirements.
- All welding to EN287, (BS4872).
- All surface mounted.
- Speed can be set from 0.5m per second to 1.5m per
second.
- Manual override facility fitted to motor in case of power
cut.
- All electronics are weatherproofed to IP56.
Crash rated at the TRL test site, the Stronguard™ Interceptor was put through its paces. The purpose of the test was to
determine the stopping or restraining potential when impacted at 90 degrees by a 7.5 ton, twin axle vehicle travelling at 80km/h (50mph).
"On impact the vehicle was immobilised by the system with no major parts of the vehicle penetrating past. The gate deformed, as designed, under the impact but remained intact such that no further vehicles could pass."
The Stronguard™ Interceptor is fully manufactured in the UK, with instant access to expert advice and spare part availability. For the complete security solution, additional gate leaves can be ordered and held in stock for immediate replacement, should the Stronguard™ Interceptor be called into action.
Standard gate height (m)
1.3 metres. Gates can be extended in height to satisfy individual requirements and for added security.
Standard gate widths (m)
3.5 metres, 4.0 metres, 4.5 metres, 5.0 metres, 5.5 metres and 6.0 metres. Non-standard widths are available on request.
Nigerian Distributor
